Hello, I just wanted to let you know I have sent off for the pins to be made!

If you don't care about the technical details of the pins, you can honestly ignore this post!

Originally, the BT pin was going to be soft enamel, with screenprint/expoy -this was mostly to have a black dye on the metal to make that stand out more.

However, I have decided to change the pin to hard enamel with black nickel and screenprint (so same as the sere kit design)

The change is because screenprint on soft enamel goes on the epoxy, which can give it a lifted/layed effect, which is good for some designs but I'm pretty sure would not work for the BT pin. This means the metal parts won't be as black, but it will still look good, I promise! I have worked with black nickel a lot, and it is very nice!

For those who don't have much experience with how pins look/are made, I guess you'll have to trust me on this one, but I just wanted to let everyone know the materials are slightly different.

Some of the lines and angles have been altered ever so slightly in the design as well, and the final colours have been chosen!

I'm keeping the surveys unlocked for now so you can change your add-ons or pin selection at any time (since there are only 28 of you)

I will be reaching out to the people who ordered commissions real soon to start sorting that!

The magnets/stickers are on order, though i still have a couple of designs to go.
Anyway, that's it for now, thanks!