Stretch Goals at 1150 and 1650! Freebies at 2k!
Heroic Snowglobe Pins

Heroic Snowglobe Pins

Enamel Pins with a Liquid Core (sparkly and interactive) inspired by some marvelous heroes.
Edit
$1,439 🎉
of $600
27
backers

Get a Backer Train Started Start a Backer Train

Share the project to start a Backer Train Back the project to start a Backer Train

Ends on at .
Share

Share

Twitter

Bluesky

Facebook

Copy Link

Edit

Heroic Pins



These 2in. Enamel Pins will be circular and about 5mm thick, with two posts on the back.

Currently, the plan is to unlock a 50 pin run for each design. However, if the campaign recieves a lot of support, the run will expand. Our first three goals are set up as follows.

Also as a small incentive for those of you who back in the first 48 hours, you get an exclusive to this kickstarter sticker sheet! It’ll feature the designs below, edited to be more sticker friendly, and some versions merging the design in a “half and half” style.


Next.

I'm making these Printed mini pins! My gravity falls and sonic printed pins are some of my best sellers at cons, so i thought i'd expand into the MCU with some Super Soldier Serum Printed pins. I call them mini but they aren't THAT small. They'll be 1.5in tall.



I also created a sticker sheet where the designs have slightly more detail, as small printed pins can only hold so much tiny text. That sticker pack, along with others, are available as add-ons! I make and print/cut them all myself, so there's not a limited quantity. There's also a few other sticker sheets that'll be available as add-ons! Daredevil, Thunderbolts and some cute fish stickers!

Take a look at them here!



We also have a series of Sticker Packs that you can check out on the add-ons page as well.

And for the last stretch goals, check these out!

Now let’s talk about a timeline. 


The campaign ends in July, and the production will start immediately. The production is quite a bit longer than my usual enamel Pins, so I expect to have the New pins in hand in late October, and to start shipment in early November. 

July: Campaign Ends. Production Begins.
August: Production. Samples.
September: Production. Arrival of Mini-pins. 
October: Production. Arrival of Pins.
November: Packing and Shipment to Backers. 

Shipping is Calclated at the end of the campaign. For Domestic Folks it should be less that $5, International friends, I cap the shipping at $15 to make it accessible to international friends. 

RISKS:


  • Issues may arise in manufacturing, delaying the delivery of promised goods. I'm extremely nervous about the possibility and will make sure everyone is well-informed of updated timelines, or in the event of any mistakes. 
  • Enamel Pins are handmade and therefore subject to mistakes. All Backers will receive A-grade pins. However, in the event of a bad batch, Backers will be given the choice to wait for the A grade re-production or choose to receive B Grade with added freebies. Hopefully, this will not occur. 
  • Colors are subject to slightly change, but I will be as firm as I can on certain aspects.
  • This is my first Backerkit campaign, but I've been on Kickstarter before! I'm determined for this to go well, but there is always, always, always the chance of it failing. In that event, you won't have to worry, as you are only charged AFTER the campaign is over and the goal is MET. You will not be charged in the event of a failure AND will get your rewards in the event of a successful campaign. So be sure to share this and spread the word to your fandom friends. 



If you believe that this project is not in compliance with BackerKit’s Community Guidelines or Terms of Service, you can file a report by sending a message via this link: Report this project