Hi everyone! Here is an update from me on the project!

As I began working with the manufacturer, I realized (was informed) that some of the designs were too fine-detailed to be able to render at pin size.

There are tolerances to how fine the metal edges can get, as well as a minimum size for any enamel colored areas.

The alternative would be to print the designs directly onto a flat pin, but I don't think that effect is quite what I want. So, I have been reworking the artwork to work at the correct size and resolution.

This has delayed the survey because I want to be able to show you the exact final designs for each pin -- so you can make a fully informed decision about each one!

All of the pins will be essentially the same as the original mockups I shared with you; just a little different in the tiny details. 

And, as promised, I will be offering (exclusive to this campaign for now) a sticker and a shirt version of each pin. I will determine case-by-case whether those will use the original, higher-resolution design, or if the revision turns out looking snazzier, I will use that instead.

I will have a further update for you as soon as everything is confirmed for production!! Thank you!!